Connections
Load
connections
Assembly
Remove the wall bracket from the rear of the AC•THOR 9s unit. To do this, slide the lock
underneath to the right.
Then fix the wall bracket to the wall with three screws. Three screws and three wall-plugs are
supplied. If the screws supplied are not suitable for the substrate, suitable screw must be
obtained.
AC•THOR
®
9s Montageanleitung / Assembly Instructions, Version 200330
Ethernet
SD Card
RJ45
Slot
Wall bracket
Signal
lock
4 Temp.
sensors
PWM
PWM
Signal
OUT
IN
Relais
16A
NC W NO
Mains connection
3 x 230 V
14