Bar - Miele A 503 Mode D'emploi

Bar

After the modules have been inserted into the bottom level, follow

the instructions in reverse to reinsert the strip.
 Damage due to bending.
Without the front strip, the mobile unit can bend during transport.
Only use the mobile unit with the strip in place.
Only carry the mobile unit with the strip in place.
A bar is inserted into the top level of the mobile unit. The bar pre-
vents modules from tipping into the bottom level when they are dis-
connected from the water connection.
The bar must be removed if a higher load is to be reprocessed in the
bottom level.
Pull the bar out of the recess on the right side.

Pull the left side of the bar out of the guide.

If the load in the bottom level allows, the bar must always be inser-
ted in the top level.
en - Areas of application
33