STERWINS 20 VGT2-28.1 Notice De Montage, Utilisation Et Entretien page 290

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 4
Ensure the cutting device remains clean and free from off-cuts that may cause it to jam. Check regularly.
FR
Release the on/off switch 3 and remove the battery pack before checking.
Trim longer grass in stages; do not cut long grass in one cut. For the best results, cut longer grass in steps.
ES
PT
IT
Edging : Illustration 4.5
EL
Ensure the knife protector 15a is removed before use.
Fold the plant protector 13 out.
Adjust the trimmer head 14 angle to 180° for edging.
PL
Line feeding
During use, the tip of the trimming line will get shorter due to wear. Regularly check the condition of the
RU
trimming line 14d and adjust if necessary.
KZ
UA
Manual feeding
Turn trimmer head 14 upside down.
RO
Press the release push button 14h while pulling on the trimming line 14d. The spool will release trimming
line. Repeat until the worn part of the trimming line 14d exceeds the distance to the knife 15.
BR
Attach the battery pack and use the product as described.
Excess line will be cut by the knife 15 and should always remain inside the radius of the guard.
EN
Auto-feeding
With the product running, release on/off switch 3 to let it stop completely.
Press the lock-off button 1 and on/off switch 3 to start the product.
After use : Illustration 5.1
Switch the product off, remove the battery back and let it cool down.
Attach the knife protector.
Check, clean and store the product as described below.
Removing and charging the battery : Illustration 6.1 and battery instruction manual
1. Press the lock button on the top center of the battery to slide it out of the product.
2. Place the battery pack into the charger by sliding it into a locked position until it clicks
NOTE : While trimming, the trimming spool may be blocked.
So the product will turn off automatically due to over current.
Therefore release the on/off switch and then start again to go
on with trimming.
NOTE : This product is equipped with an auto-feed head. Do
not bump the trimming head on the ground as this would
damage the product.
WARNING! The trimming line will be thrown out!
Danger of injury especially for bystanders!
NOTE : The line will extend about 8 mm with each stop and
start until the line reach the length of the knife. Do not stop
and start frequently as the trimming line may auto-feed
unintentionally and cause a lot of line to be wasted.
290

Publicité

Table des Matières
loading

Table des Matières