Installing Side Handle - Milwaukee 6088-30 Manuel De L'utilisateur

ASSEMBLY
To reduce the risk of injury, always
WARNING
unplug tool before changing or
removing accessories. Only use accessories
specifically recommended for this tool. Others
may be hazardous.
To reduce the risk of injury when grinding, always
use properly installed guards.
Installing/Removing/Adjusting the Guard
(Select Models)
1. To install the guard, unplug the tool and place
it upside down on a level surface. Remove any
accessories from the spindle. WARNING! Always
unplug tool before changing or removing acces-
sories.
Line up the tabs with the tab slots. Then press the
guard down onto the tool.
Tab slot
Tab slot
Guard adjustment
lock lever
Guard adjustment
lock lever
Press in the guard adjustment lock lever and rotate
the guard to one of the detent slots. The lock lever
must engage with one of the detents.
2. To adjust the guard, press in the guard adjust-
ment lock lever and rotate the guard to one of
the detents. WARNING! Always adjust the guard
to provide the operator with maximum protection
while operating.
3. To remove the guard, unplug tool and place it
upside down on a level surface. Remove any ac-
cessories from spindle.
Press in the guard adjustment lock lever and rotate
the guard to line up the tabs with the slots. Then
lift the guard straight up and away from the tool
1
Operator's Zones
Installing/Removing Type 1 Guard
1. To install the guard, unplug tool and place it upside
down on a level surface. Remove any accesso-
ries from spindle. WARNING! Always unplug tool
before changing or removing accessories.
2. Loosen the guard screw and slip the guard over
the spindle.
Adjusting
shoe
Tab slot
3. To adjust the guard, unplug the tool, loosen the
guard screw, rotate the guard to the desired posi-
Guard
tion and retighten the guard screw. WARNING!
Always adjust the guard to provide the operator
with maximum protection while operating.
4. To remove the adjusting shoe, loosen the wing nuts,
Lock lever
slide the shoe over to the access holes and lift out.
must
engage one
To install the adjusting shoe, insert the head of the
of detents
carriage bolts into guard access holes and slide the
shoe over to the far edge of slots. Adjust shoe to
desired position and tighten wing nuts securely.
5. To remove the guard, unplug the tool, remove the
accessories and reverse the procedure.
WARNING
tool. Hold securely.
The side handle may be installed on either side of
the gear case. Position the side handle in the loca-
tion which offers best control and guard protection.
To install, thread side handle into side handle socket
and tighten securely.
6
1
Assembly/Adjusting Shoe
Carriage bolt and wingnut
Guard
Guard screw
To reduce the risk of injury, always
use a side handle when using this

Installing Side Handle

1
1
Spindle