Cleaning And Maintenance; Troubleshooting - BOMANN VS 3171 Mode D'emploi

Cleaning and Maintenance

Cleaning
Cleaning Cleaning
WARNING: WARNING: WARNING: WARNING:
• Always switch off and disconnect the appliance
from the power supply before cleaning and user
maintenance.
• Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock! Risk of electric shock! Hot steam could damage Risk of electric shock! Risk of electric shock!
the plastic parts.
• The appliance must be dry before restarting oper-
ation.
CAUTION: CAUTION: CAUTION: CAUTION:
• Do not use a wire brush or other sharp, abrasive
items.
• Do not use any acidic or abrasive detergents.
• Do not damage the refrigerant circuit.
Cleaning the appliance including interior Cleaning the appliance including interior Cleaning the appliance including interior Cleaning the appliance including interior
• Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
warm water and mild detergent.
• Remove for that the appliance content and stor-
age at a cool location.
• Clean the thaw water discharge channel / opening
carefully e.g. with a pipe cleaner.
• After everything was thoroughly dried, you can
restart the operation.
Defrosting Defrosting
Defrosting Defrosting
The appliance has an automatic defrosting system.
During defrosting water drops drains off at the back
of the cooling chamber. The thaw water running
through a channel, is collected in a drip tray located
on the compressor, where it will evaporate.
Make sure the water discharge opening does not get
clogged. A light formation of ice on the interior back
during operation is normal.
and Maintenance
and Maintenance and Maintenance
Reverse the bulb Reverse the bulb
Reverse the bulb Reverse the bulb
Specification: 220- - - - 240 V Specification: 220 Specification: 220 Specification: 220 240 V 240 V 240 V~ ~ ~ ~ , max. 15 W
• Loosen the screw of the lamp cover and remove
the cover to the back.
• Replace the defective bulb.
• Reattach the lamp cover and tighten the screw.
• Reconnect the appliance and put into operation
again.

Troubleshooting

Troubleshooting
Troubleshooting Troubleshooting
Before you contact an authorized specialist Before you contact an authorized specialist Before you contact an authorized specialist Before you contact an authorized specialist
Problem Problem Problem Problem Cause / Action Cause / Action Cause / Action Cause / Action
Appliance is - Insert the power plug correctly or check
not working the fuse.
or not - Check the temperature setting.
properly - Check the ambient temperature.
- Unblock the ventilation openings, install
the appliance freely.
Stored food - Check the temperature setting.
is too warm - Open the door only as long as neces-
sary.
- Check the location.
Loud noise - Check the appliance position.
during oper- - See the section "Operating noise".
ation
Water on the - Check the temperature setting.
appliance - Clean the water discharge channel /
bottom opening.
Interior light - Insert the power plug correctly or check
is not work- the fuse.
ing - See the section "Reverse the bulb".
Water on the On days of high humidity, condensation
outer sur- might occur on the outer surface of the
face. appliance. No malfunction!
NOTE: : : : NOTE
NOTE NOTE
If a problem still persists after following the steps
above, contact your trader or an authorized techni-
cian.
21
, max. 15 W , max. 15 W , max. 15 W