BOMANN VS 3171 Mode D'emploi page 18

Gap to the back and to the side walls each
-
approx. 5 cm;
Place the appliance so that the appliance door
-
can open without being impeded.
• Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
For information on the climate class, please refer
to chapter "Technical Data" or to the rating label
located in the interior or on the rear side of the
appliance.
• Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
• Avoid the installation: Avoid the installation: Avoid the installation: Avoid the installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e.g. outdoors,
-
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
Assembling the door handle Assembling the door handle
Assembling the door handle Assembling the door handle
Remove the cover caps from the door outer side and
tighten the handle with the delivered screws into the
underlying holes. Put the included screw covers on.
Electrical connection Electrical connection
Electrical connection Electrical connection
WARNING: WARNING: WARNING: WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock! shock
shock shock
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
WARNING: WARNING:
WARNING: WARNING:
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
CAUTION: : : : CAUTION
CAUTION CAUTION
In case of disconnection or power failure:
Wait for approx. 5 minutes before restarting.
-
Check the operation settings.
-
• Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the door opening Reverse the door opening Reverse the door opening Reverse the door opening
If required, the door openings can be moved from the
right (supplied condition) to the left side.
WARNING: WARNING: WARNING: WARNING:
When replacing the door stops, the appliance must
be disconnected from the power supply. Always un-
plug the appliance first.
NOTE NOTE: : : : NOTE NOTE
• When installing, ask another person to assist.
You possibly need:
•
driver as well as a thin-blade screwdriver.
• Remove the cover caps on
the top cover. Loosen the
screws underneath and re-
move the top cover.
• Transfer the blind cap of the
appliance cover at the oppo-
electric
electric electric
site side.
• Dismount the upper door
hinge. Open the appliance
door a little and lift it out of the lower door hinge.
18
screw wrench, Phillips screw-