Dmx-Controlled Operation; Dmx-Protocol - EuroLite TS-155 Mode D'emploi

Call up the internal program
In order to call up the internal program, set DIP-switches No. 9 and 10 to On.
Master/Slave-operation
Connect the master and slave-devices as desribed above and set the DIP-switches accordingly.
Please note: If you wish to change from one operating mode into another, you have to unplug the projector
from the mains and plug it again.

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.

DMX-protocol

Control channel 1 - Horizontal movement (Pan) (within 180°)
Push slider up in order to move the mirror horizontally (PAN).
Gradual mirror adjustment from one end of the slider to the other (0-255, 128-center). The mirror can be
stopped at any position you wish.
DMX-value Feature
0-255 Gradual adjustment of the mirror position from left to right
Control channel 2 - Vertical movement (Tilt) (within 90°)
Push slider up in order to move the mirror vertically (TILT).
Gradual mirror adjustment from one end of the slider to the other (0-255, 128-center). The mirror can be
stopped at any position you wish.
DMX-value Feature
0-255 Gradual adjustment of the mirror position from up to down
Control channel 3 - Colour-wheel
DMX-value Feature
0-31 Open/white
32-63 Red
64-95 Yellow
96-127 Violet
128-159 Green
160-191 Orange
192-223 Blue
224-255 Pink
Control channel 4 - Gobo-wheel
DMX-value Feature
0-31 Open
32-63 Gobo 1
64-95 Gobo 2
96-127 Gobo 3
128-159 Gobo 4
160-191 Gobo 5
192-223 Gobo 6
224-255 Gobo 7
29/58
51786025_V_1_4.DOC