Inserting / Changing The Battery; Start-Up; Switching On And Off - Parkside PTIA 1 Instructions D'utilisation Et Consignes De Sécurité

The display is covered by protective film to protect from transport damage.
5
First remove the protective film.
To operate the product, insert the included battery (9 V block). Proceed as described
below:

Inserting / changing the battery

T o insert / change the battery
the battery cover in the direction of the arrow and flip open.
I f applicable, remove the old battery and insert a new one. If necessary, clean
the contacts of the battery compartment and the battery. Only use a 9 V block
battery type 6F22 or 6LR61.
E nsure the correct polarity when inserting the battery. This is indicated on the
battery cover (Fig. C).
C lose the battery cover.
Your infrared thermometer is now ready for use.

Start-up

H old the handle of the product so the index finger can operate the Measure
button and the thumb buttons
3

Switching on and off

P ress the Measure button
light up and a brief tone will sound.
P ress and hold the °C / °F / SET button
off the product. Two brief tones will sound.
W hen the product is no longer being used, the backlight of the display swill
switch off after approx. 15 seconds. After approx. 60 seconds the product
will automatically switch off; this is indicated by two brief tones.
24 GB/IE
, open the battery cover
13
to .
10 12
to switch on the product. The display
3
for approx. 3 seconds to switch
11
. To do so, slide
4
will
5