ohmex IRS 1980 Manuel D'utilisation page 75

IRS 1980
☞
Place the ironing system on a horizontal and stable support surface.
Make sure that it is resting securely.
Place the appliance far from sinks and taps.
• Eventual repairs must be performed only by specialists which have original
spare parts supplied by the manufacturer.
Repairing the appliance by yourself could be extremely dangerous.
• In compliance with the current regulations, an appliance out of order must
be rendered unusable, by cutting the power cord, before tossing it.
• Do not use the appliance in gas-filled environments.
• Clean the appliance using only water. Do not use trichloroethylene, solvents
or abrasive detergents.
• Never place the ironing system in the vicinity of petrol, oil or other highly
flammable substances. Risk of explosion and fire!
• Do not store the steam ironing system in areas exposed to frost.
Water that freezes in the water reservoir, boiler unit or steam hose can cause
serious damage.
• Do not remove the tank (2) while the appliance is connected to the supply
network.
• Do not move the appliance while it's working or if the plate (9) is still hot.
• There may be noise due to expansion of the ironing system when the appliance
is used for the first time; everything is normal!
• At first use the appliance could release some smoke and some drops of water
could come out of the plate (9). This phenomenon will be over after a few
seconds.
• Avoid direct contact between the hot plate (9) and the appliance power cords;
• Prevent that the power cord and the steam pipe (7) come into contact with
the iron hot plate (9).
GENERAL WARNINGS
EN
71