ohmex IRS 1980 Manuel D'utilisation page 74

EN
☞
The installation must be carried out following the manufacturer
instructions. A wrong installation could cause damages to people,
animals or things, for which the manufacturer cannot be considered
liable.
• To avoid dangerous overheatings, to straighten the whole power cord is
recommended.
• Do not leave the appliance unnecessarily inserted. Disconnect the plug from
the mains power supply when the appliance is not used.
• If the power cord of this appliance is damaged, it must be changed exclusively
by a technical assistance centre authorized by the manufacturer, since special
tools are necessary
The electrical safety of this appliance is guaranteed only when it is
correctly connected to an effective grounding system as specified
by the current norms on electrical safety.
• It's necessary to check this fundamental safety condition and, in case of doubts,
ask for an accurate check of the system by professionally qualified personnel.
The manufacturer cannot be considered liable for possible damages caused
by the lack of grounding of the system.
• Before carrying out any operation turn off the appliance and disconnect the
power plug from the outlet.
• Don't connect the appliance to the power supply through external timers or
remote control systems.
☞
Make sure that the power cord or iron does not protrude from the
ironing board in order to prevent someone from inadvertently pulling
on them and turning over the ironing system.
Risk of burns!
70
GENERAL WARNINGS
.
IRS 1980