Kenmore 665.1472 Série Guide D'utilisation Et D'entretien page 8

8. Determine whether you want the compactor cabinet or
drawer front flush with the kitchen cabinet face.
Using 2 - #8 - 18 x ⁵ ₁₆" mounting screws (provided in
conversion kit), attach the retaining brackets (provided in
conversion kit) to the compactor cabinet top as needed. See
"Accessories."
NOTE: Installation hardware is not provided with full
cabinet models. See "Accessories" for ordering conversion
kit.
If the compactor cabinet face is to be flush with the
kitchen cabinet face, place retaining bracket mounting
screws through "1."
If the compactor drawer front is to be flush with the
kitchen cabinet face, place retaining bracket mounting
screws through "3."
If the compactor is to be midway between "1" and "3,"
place the retaining bracket mounting screws through
"2."
A. Countertop
B. Retaining bracket (provided in conversion kit)
9. Slowly lift the front slightly and roll compactor into the
kitchen cabinet opening.
10. Using 2 - #8 - 18 x ¹ ₂" mounting screws (provided in
conversion kit), fasten the retaining brackets (provided in
conversion kit) to the countertop with the mounting screws.
Countertop mounting
A
B
C
A. Countertop
B. Retaining bracket (provided in conversion
kit)
C. Mounting screw (provided in conversion kit)
8
A
B
3
2
1
NOTE: If retaining brackets cannot be attached to the
underside of countertop, attach mounting clips (provided in
conversion kit) to retaining brackets. Fasten compactor to
kitchen cabinet face with mounting screws through the
mounting clips.
Cabinet-face mounting
A
B
A. Mounting clip (provided in conversion kit)
B. Kitchen cabinet
C. Retaining bracket (provided in conversion kit)
D. Mounting screw (provided in conversion kit)
11. Grasp sides of compactor drawer and place bottom of
drawer into tracks.
12. Lift at the handle so drawer will go over drawer stops.
13. Close drawer.
14. Check to see whether drawer opens freely. If the toe plate
rubs against floor, see "Adjusting the Toe Plate" for further
instructions.
Adjusting the Toe Plate
If the toe plate rubs the floor covering, the toe plate clearance
may be changed as follows:
1. Mark on each side of the toe plate the amount of toe plate
that rubs the floor covering.
2. Remove the drawer from the unit. See Step 3 in the
"Unpacking" section.
3. Use a ruler and a pencil or chalk to draw a line between the
marks on each side of toe plate.
4. Use scissors or utility knife to cut toe plate along line.
5. Replace drawer. If toe plate still rubs floor covering, repeat
steps 1-4.
C
D