Compactor Use; How The Compactor Works; Loading; Starting The Compactor - Kenmore 665.1472 Série Guide D'utilisation Et D'entretien

How the Compactor Works

The compacting ram is the part of the compactor which
compresses the trash. The compacting ram does not go to the
bottom of the drawer. You will not see compacting of trash the
first few times you load the compactor.
NOTE: The compactor drawer should be more than ¹⁄₂ full
before the compactor can begin to compress the load.
You may hear a noise when glass breaks. Strong glass bottles
may not break at all. The trash in a full compactor bag will be
about ¹⁄₄ the size of its original bulk.
Load bulky trash, bottles, and cans in the center of the drawer.
Bottles or cans not placed in the center may become caught
between the ram and the drawer. The Drawer Monitor Switch
then senses a "misload" and causes the ram to return to the "up"
position without compacting.
IMPORTANT: Do not push items down into compactor with
hands or feet.
NOTE: You will not see compacting of trash the first few times
you load the compactor. The compactor drawer should be
about ¹⁄₂ full before the compactor can begin to compress the
load.
1. Open the drawer. Lift and pull the handle or press the foot
pedal to open the drawer.
NOTE: Pressing the foot pedal opens the container only 3"
to 6" (7.6 cm to 15.2 cm), depending on the load.
2. Place trash in compactor.

COMPACTOR USE

Loading

Wrap or cover wet or messy trash.
Do not compact items that may develop offensive odors
such as raw meat, fish, grapefruit rinds, disposable
diapers, or personal hygiene items.
Load bottles or cans on their sides in the center of the
drawer. Do not load bottles in an upright position.
3. Close the drawer.

Starting the Compactor

To start and stop the compactor
1. To start the compactor:
Turn the Key-Switch to ON.
Press ON.
Press START. The compactor will automatically stop at
the end of the cycle.
2. To stop the compactor during a cycle:
Press OFF.
Press ON. The compacting ram will rise. When the ram
stops rising, you can open the drawer.
To remove the Key-Switch
1. Turn the Key-Switch to the OFF/LOCK position.
2. Remove and store key out of children's reach.
11