3
Equipment controls
C) Large wand control buttons
The ON button is used to give power to the cleaning
accessory. When the pumping mode is set to Manual, press
the ON button to activate the pump. Press and keep the
button pressed to get continuous flow of liquid.
However, if the pumping mode is set to automatic, press
the ON button once to activate the pump. To stop the
pump, press the OFF button. When finished working
with the machine (in either mode) make sure to press
the OFF button.
Once the ON button is pressed, there will be continuous
power at the tip until the OFF button is pressed.
Cleaning
Accessory
D) Fume elimination system (patented)
The SURFOX 304 machine comes with the integrated fume
elimination system. This system provides for better work-
ing conditions. Although the fumes are non-toxic and non
hazardous, they can be uncomfortable when working in
confined areas.
To activate this feature simply connect a compressed air line
(150 PSI max., 80 PSI min.) to the fitting at the back of the
machine. The fume elimination system is automatically ac-
tivated when the ON button is pressed on the large wand.
The fume elimination system is turned OFF when the OFF
button on the large wand is pressed. If the fume elimination
system is not wanted, simply disconnect the compressed
air line.
The working principle is quite simple and highly effective;
the air comes out through the small openings behind the
cleaning accessory. This preset regulated air pressure con-
denses the vapors out of the air.
6
ON
OFF
E) Fastening inserts on the large wand
This unit comes with a quick-release adaptor on for the
cleaning acessories. The brush holder or tungsten insert
may be rotated counter clockwise to release it. Similarly,
you can fasten the cleaning accessories by rotating them
clockwise. You can also add the 2 x set screws to fix the
tungsten or the brush holder permanently.
Compressed
air line fitting
Cleaning accessory close up
Small openings