Cleaning And Maintenance; Troubleshooting - Imetec E1202 Instructions D'utilisation

WARNING! DO NOT use the appliance empty.
EN
WARNING! Switch the appliance off before removing the
jug.
WARNING! DO NOT use the safety system as an alternative
to the on/off switch.
• Pour the liquid and solid ingredients into the blender jug without exceeding the maximum level
indicated on the jug itself.
• Close the jug with the lid.
• Connect the power plug to the mains socket.
• Start the blender by turning the on/off control to the desired position.
• If necessary, add extra liquid through the hole in the lid.
• Stop the appliance by turning the on/off control to position "0".
• Remove the plug from the power socket.
• Lift the jug from the motor unit.
• Remove the lid from the jug.
• Pour out the mixture.
WARNING! Always disconnect the appliance from the socket
before cleaning or performing maintenance.
• Clean the accessories according to the instructions in the "Cleaning before first use" chapter.
• Wipe the motor unit with a dampened and thoroughly squeezed out sponge.
• Dry with a dry cloth.
If one of the following problems occurs, adopt the solution indicated:
Ice is not crushed properly
14

CLEANING AND MAINTENANCE

TROUBLESHOOTING

Problems Solutions
Always crush ice using the impulse function and
plenty of liquid.
If the ice remains above the blades, turn the
appliance off and stir the contents with a spatula.
Refit the lid and use the impulse function.