Beta 1498-16A Mode D'emploi page 16

INSTRUCTIONS FOR USE
After setting the battery voltage to the 12V mode, set the charging parameters using the "Function" key:
4°
8°
16°
4°
8°
16A
4A
8A
16A
For WET batteries which have not been used for a long time and in which the acid has stratified.
CAUTION: Because of the high voltage reached during the charging cycle, the battery recovery
4A-8A-16A process must be performed with the battery disconnected from the vehicle. Recovery with the battery
AGM connected to the vehicle may result in damage to the vehicle's electronics. (Only in 12V mode)
SHOW SHOW ROOM function: 13.8V.
ROOM This function is used to keep all the equipment of the vehicle running during demos in the car
shop. (Only in 12V mode)
SUPPLY Power supply function: 14.0V.
Keep the "Mode" key pressed for 5 seconds to enable this function, which is used to keep a
vehicle's memory banks active while the battery is being changed or whenever the battery is
disconnected from the vehicle's circuit. (Only in 12V mode)
CAUTION: IN THIS FUNCTION, THE BATTERY CHARGER IS NOT PROTECTED AGAINST
POLARITY REVERSAL. RISK OF DAMAGE!
16
1498_16A.indd 16
Charge for 12V batteries, 5Ah to 80Ah
Maintenance charge for 12V batteries, 5Ah to 120Ah
Suitable for charging WET and Gel batteries
Charge for 12V batteries, 50Ah to 160Ah
Maintenance charge for 12V batteries, 50Ah to 250Ah
Suitable for charging WET and Gel batteries
Charge for 12V batteries, 90Ah to 360Ah
Maintenance charge for 12V batteries, 90Ah to 550Ah
Suitable for charging WET and Gel batteries
Charge for 12V batteries, 5Ah to 80Ah
Maintenance charge for 12V batteries, 5Ah to 120Ah
Suitable for charging AGM-START&STOP and AGM-SPIRAL and EFB or WET
batteries with temperatures below 5 °C
Charge for 12V batteries, 50Ah to 160Ah
Maintenance charge for 12V batteries, 50Ah to 250Ah
Suitable for charging AGM-START&STOP and AGM-SPIRAL and EFB or WET
batteries with temperatures below 5 °C
Charge for 12V batteries, 90Ah to 360Ah
Maintenance charge for 12V batteries, 90Ah to 550Ah
Suitable for charging AGM-START&STOP and AGM-SPIRAL and EFB or WET
batteries with temperatures below 5 °C
Charge for 12V batteries, 5Ah to 80Ah
Maintenance charge for 12V batteries, 5Ah to 120Ah. Suitable for charging lithium
batteries: LiFePO4 (do not charge any other types of lithium batteries)
Charge for 12V batteries, 50Ah to 160Ah
Maintenance charge for 12V batteries, 50Ah to 250Ah. Suitable for charging lithium
batteries: LiFePO4 (do not charge any other types of lithium batteries
Charge for 12V batteries, 90Ah to 360Ah
Maintenance charge for 12V batteries, 90Ah to 550Ah. Suitable for charging lithium batteri-
es: LiFePO4 (do not charge any other types of lithium batteries)
Lithium batteries are fitted with the BMS device, which, under some circumstances,
prevents the charge cycle from starting; in this case, to start charging the battery, press the
"Function" button for 5 seconds, after setting the battery charger to the lithium mode.
EN
07/11/19 15:36