General Note - Goobay DF 1730 LCD Mode D'emploi

• Install and store the product and its accessories in a way persons cannot be injured, or
objects not be damaged for example by dropping or stumbling.
• Remove or store the packing materials well, because children may cut themsel-
ves on them while playing. Furthermore, there is a risk of swallowing and inhalating of
incidentals and insulating material.
• Also read the User's manual of your connected device for checking the compatibility
and fitting of the connectors to the power supply, and the other way round.
• A defective device may not be put into operation, but must be disconnected from mains
and protected against further use. Repairing, such as assembling and disassembling
the housing is only allowed to skilled professionals. By repairing it yourself you will
loose all warranties and there is a risk of electric shock and short circuit.
• Drive the product only with earthed 220-240 V ~ / 50 - 60 Hz a.c. networks.
• Unplug the mains cable when not in use and during thunder storms.
• Avoid places with high humidity, or places which might come into contact with water.
• Do not place things on the device.
• Keep enough space around the device for good ventilation.
• Never plug things into the ventilation slots.
• Mind and follow the terms of law and health care for using the device in industry.
• Never expose the product to high mechanical pressure.
• Do not modify or change the product or its accessories! Also mind chapter "warranty
and liability".
• Do not use damaged parts.
• The device may only be installed and used in dry interior rooms.
• The device may growing warm during use.
• Place the product only on dry, solid and fir-proof surfaces. Do not short circuit the DC
connection.
• Do not overload the unit. Find the maximum current at chapter "Specifications".
• The mains connection of the unit must be earthed!
• Mind the ventilation and heat reduction at full load.
• Do not exceed the permitted input amounts.
• Only meassure with dry clothing and if possible, with applicable rubber gloves.
• Mind the notes on safety on the product and check all test leads and feeler heads for
defective isolation.
• Avoid placing the device near to magnetic fields, like motors or transformers.
• Led the device acclimate after transporting until room temperature is reached, before
use.
• Place the device in a way, reaching the operating elements without problems.

5 General Note:

Your laboratory power supply is a precise, direct current controlled power supply and the
output voltage is freely adjustable from 0-30V DC. The voltage and current controls
change automatically. The current is freely adjustable in the ampere section from 0-3 A
and model 20327 from 0-10 A. The device includes a LCD/LED display for each channel of
output current and output voltage.
9