Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
13 status LED indicate:
LED
Power 1
Power 2
DIAG
Bicolor
C-KEY
Orange/
WLAN
Bargraph
Link
Tx/Rx
(ports 1&2)
100 Base T
(ports 1&2)
If it is not possible to shutdown the
power
supply,
accessible by a hole located just in
front of the supply connector allows
resetting the product. You can use, for
example, a paper clip to press the
button. The press must be brief: if it
takes more than two seconds, the
product will reset to factory settings.
LEDs definition
Color
This led is ON when a power supply is connected
Green
to pin PWR1 and GND1 of the power connector or
in case use of PoE if this function is available.
This led is ON when a power supply is connected
Green
to pin PWR2 and GND2 of the power connector.
This led lights up during a few seconds after
Red
power up. When light up it indicates a product
dysfunction.
Off:
Orange:
Green:
Green
Blinking:
Blue
Flashing according to WLAN Tx/Rx activity.
In Bridge mode, the four bars show the receive
Green
level of the Wi-Fi interface. In AP mode, the four
bars blink until a client is connected.
Lit when the link is established, blinks according
Green
to TX/RX activity.
Indicates the connection speed: light off = 10
Yellow
Mbps, yellow = 100 Mbps.
a
micro-switch
Description
no C-Key is detected.
the C-Key data is invalid or corrupted.
the C-Key data is valid.
during reads and writes to the C-Key.
RESET
-8-
Publicité
Table des Matières
