First Start-Up - Maddalena UniCo Guide Rapide

EN
2

First start-up

WARNING!
l
UniCo should only be used by
trained and instructed personnel.
Before using UniCo, a full charge cycle of
the batteries must be carried out.
After the first charging operation, the instru-
ment can remain connected to the power
supply during use.
Connect UniCo to a PC/Tablet or to the
charger and connect this to the power sock-
et.
The red CH LED comes on and stays on until
the batteries are fully charged.
Disconnect and use the instrument only
when the batteries are fully charged and the
red LED has gone out.
Use a standard smartphone charger (not
supplied) or one with the following specifi-
cations (5 VDC, 500 mA).
WARNING!
l
An inappropriate charger may
cause irreversible damage to the
batteries.
WARNING!
l
UniCo cannot be recharged when
the ambient temperature ex-
ceeds 35°C.
To communicate with Windows PCs, it is
necessary to install USB drivers, which can
be downloaded from https://www.ftdi-
chip.com/Drivers/VCP.htm.
In order to communicate with the PC/Tablet
via BlueTooth, you need to add UniCo to the
BlueTooth pairing list of the device in the
standard Windows or Android mode.
11