General Characteristics; Contents Of The Box - Reya DOLPHIN PRO 24V40A Notice Technique

GENERAL CHARACTERISTICS

NOT-DOLPROREYA-03
Maintenance precautions
To prevent any risk of electric shock
during maintenance operations, ensure that the
following recommendations are scrupulously
observed before performing any maintenance
on the device:
4All maintenance operations must only be
carried out by a suitably qualified technician.
4In the event of damage to the mains leads
and/or batteries, these may only be replaced by
a qualified person, to avoid any danger.
4The mains power supply must be
disconnected (cable or switch).
4 The -DC or -BAT supply on the battery must
also be disconnected to prevent any transfer of
power.
4To allow the high voltage capacitors to
discharge (on the circuit board), wait for 5
minutes before carrying out any work inside the
housing.
4The fuses must be replaced by fuses with strictly
identical characteristics and performance levels.

CONTENTS of the BOX

NOT-DOLPROREYA-03
RECEIPT OF THE PRODUCT
Contents of the packaging
4The charger.
4Its user manual.
4Its mains cable gland
accompanied by its mounting
nut (to be installed on the housing
prior to connection).
4Its battery temperature sensor
(24V100A version only)
Checking
Check the product's identifi-
cation label, attached to one
side of the product, to ensure
that the technical details
actually meet your needs (mains supply voltage,
charger capacity, etc.).
Installation introduction
The charger is attached using 4 x 4mm Ø screws
(not supplied), to a "robust" mounting or wall.
Ideally, the product should be in a vertical
position, with the cable outlet pointing
downwards. Clearance of at least 10 cm must be
allowed around the device to guarantee
optimum convection, in particular along the
sides allowing the air needed for ventilation to
flow in and out.
The circulation and convection direction of the
air inside the charger is from right to left, viewed
from the front of the product (see photo below).
UK