Initial Setup; Positioning And Connection; Operating Modes; Operation Directly On The Device - Meyra iMove Mode D'emploi

INITIAL SETUP

INITIAL SETUP
4

4.1 POSITIONING AND CONNECTION

A level and low-vibration surface is important to ensure the iMOVE operates smoothly. The iMOVE is only authorised for indoor use.
Having properly positioned the iMOVE, insert the connector plug into the socket. Once positioned and connected, the device is
immediately ready for use.
CAUTION!
!
The device must not be used in wet rooms. Temperature range from 0 to
+30 degrees Celsuis. The device switches off automatically around four hours after the last command.

4.2 OPERATING MODES

The iMOVE can be operated directly on the device, by remote control and from your smartphone or tablet with the free iMOVE app.

4.2.1 OPERATION DIRECTLY ON THE DEVICE

There are three buttons on the left-hand side of the iMOVE with which you can operate the device.
1 STARTING AND STOPPING
Press to start and stop the iMOVE.
When is pressed, the iMOVE automatically starts with a frequency of 2 hertz.
Pressing again switches the iMOVE off. The backlights of the
2 SETTING THE FREQUENCY
Press to increase the frequency during the exercise programme.
Press to decrease the frequency during the exercise programme.
20
and buttons go out.

4.2.2 OPERATION USING THE APP

The iMOVE app is available for iOS and Android. Download the app free of charge on to your smartphone or tablet from App Store
(iOS) or Google Play Store (Android). You first have to pair your smartphone or tablet with the iMOVE via Bluetooth. In order to do so,
check which mode the iMOVE is in. If the button is lit up blue, the iMOVE is in "smartphone" mode. If the
the iMOVE is in "remote control" mode. (To switch between "smartphone" and "remote control" mode see 4.2.3.) The
lighting up blue indicates that the iMOVE is ready to pair with your smartphone. Start the iMOVE app on your smartphone or tablet
and open the Bluetooth settings at the top right in the iMOVE app. Select your iMOVE to pair the device.
1 STARTING AND STOPPING
Pressing the START button automatically starts the exercise programme with a frequency of 2 hertz.
Press PAUSE to halt the exercise during use and continue it at a later time.
Pressing STOP ends the exercise.
2 SETTING THE FREQUENCY
You can adjust the frequency either prior to starting the exercise programme or during the exercise.
Use the slider or the plus and minus buttons to increase or decrease the frequency.
3 SETTING THE STOCHASTIC
Use the stochastic slide button to switch the stochastic on and off. Stochastic means that the frequency changes
at random in a range from -2 to +2 units in relation to the selected frequency.
4 EVALUATION
Having completed the exercise, a brief evaluation of your exercise unit is displayed.
1
INITIAL SETUP
button is lit up white,
button
2 3 4
21