Use
PLEASE NOTE!
■
CAUTION – Danger of scalding from hot steam! Be careful when pouring out hot
water.
■
CAUTION – Danger of scalding! The device should only be used out of the reach
of small children and animals. The mains cable must also be kept out of the reach of
children. Otherwise they might use the cable to pull the device down on themselves.
■
The surfaces of furniture may possibly contain elements which can attack and soften
the adjustable feet of the base station. If necessary, place a suitable pad below the
adjustable feet.
If the kettle has accidentally been operated without any water in it, it switches
itself off automatically. Allow it to cool down before using it again.
Setting Up and Filling
1. Wind up or unwind the mains connecting cable on the bottom of the base station (3)
to the length you want and then place it in the slot which is provided for it on the edge
of the base station.
2. Insert the mains plug into a properly installed socket that is easily accessible.
3. Place the base station on a dry, even, fi rm and heat-resistant surface. Do not place
the device below kitchen wall units or similar cupboards. The rising steam could
cause damage to them!
4. Fill the kettle (5) with at least 0.5 litres (MIN marking) and max. 1.7 litres (MAX
marking) of water. Insuffi cient water will cause the device to switch off prematurely. If
the MAX marking (6) is exceeded, water could splash out during the boiling process.
There are two possibilities for fi lling:
5. Place the kettle on the base station.
6. Choose one of the functions described below (boil water, heat up water, keep-warm
function). After the end of the function, take the kettle off the base station and care-
fully pour the water into a vessel.
All functions can be cancelled at any time by pressing the
the kettle off the base station.
Boiling Water
Press the
button (11) for a short time. The LED lighting (4) displays all colours in
succession. The device switches on and heats the water up to 100°C. The LED lighting
is lit constantly red.
The device switches off automatically when the water has boiled.
08012_DE-EN-FR-NL_A5_V1.indb 17
08012_DE-EN-FR-NL_A5_V1.indb 17
17
a. Aim the jet of water directly at the lid insert. The pressure
causes it to fl ip down automatically and the water can fl ow
into the kettle.
b. Take off the lid (9) and pour water directly into the kettle.
Then put the lid back on. The correct position is indicated
by the arrows on the kettle and lid. The lid must be heard
to engage in place.
EN
button (11) or taking
06.07.2018 07:37:21
06.07.2018 07:37:21