Stereo Pair; Setting/Playing Back Music - Yamaha MusicCast WX-030 Mode D'emploi

OTHER FUNCTIONS AND INFORMATION
You can use two WX-030 units to reproduce stereo sound by setting each speaker as the right
or left speaker. Set the left and right speakers separately by following the steps below.
Left
speaker WX-030

Setting/Playing back music

A
Connect each WX-030 to the same network by using the dedicated app "MusicCast
CONTROLLER."
If the WX-030 is linked to another MusicCast unit, first disconnect the link by using the dedicated app "MusicCast
CONTROLLER."
B
Tap (power)/CONNECT of each unit to set them to standby mode.
C
Tap and hold the following together for 3 seconds to set the left/right speakers.
1 For setting the left speaker:
Indicators light from right to left repeatedly (refer to
of the table), and the unit enters pairing standby
mode.
2 For setting the right speaker:
Indicators light from left to right repeatedly (refer to
of the table), and the units start pairing.
After paring is completed, the indicators light from the center to both sides (refer to
return to the normal status.
12
En

STEREO PAIR

Right
speaker
WX-030
and
Indicator display during the Stereo Pair
Stereo Pair
Start Pairing/
Checking the
Left and Right
Speaker
and
Pairing
Completed
Note
• To use the Stereo Pair function, you need two
WX-030.
• Before setting the Stereo Pair, update the
dedicated app "MusicCast CONTROLLER"
and the firmware of both units to the latest
version (☞ P.7).
• Stereo Pair is available only when the
Network Standby mode of the unit is enabled.
Indicator display
status
Left speaker
Right-to-Left
Center to both sides
of the table), and all indicators
Right speaker
Left-to-Right