Important; Use & Operation; Control Panel - Honeywell HL10 Série Mode D'emploi

INSTALLATION (CONTINUED)

IMPORTANT:

• Do not replace or lengthen the exhaust hose as this could cause the unit to malfunction.
NOT RECOMMENDED
WARNING: Any warranties included with this product will be voided if an extra extension hose is added
to the originally provided installation kit or if the installation is performed differently than the manufactur-
er's instructions, without proper consultation. Please contact Customer Support for help with installation
if needed.
• The supplied exhaust hose has a diameter of 5.9 inches (15 cm) and can be extended from 14.2
inches to 47.2 inches (36 cm to 120 cm).
• Do not bend (to the extent shown below) the exhaust hose. A bent hose will block exhaust air and
cause the unit to malfunction or shut-off.
• Make sure the back of the unit is at least 50 cm / 20 inches away from the wall. Do not place the unit
in front of curtains or drapes as this could obstruct the airflow.
USE & OPERATION

CONTROL PANEL

Model without Heat Mode
HIGH
MID
LOW
(6)
Model with Heat Mode
HIGH
MID
LOW
FUNCTION BUTTONS
POWER CONTROL
The Power Control
outlet, the POWER indicator light will illuminate red indicating the unit is in a Standby Mode, ready to be
switched on at anytime. The air vent will automatically open when the unit is turned ON and automatical-
ly close when unit is turned OFF.
COOL
DRY
C
o
F
FAN o
(5) (4)
COOL
DRY
o C
o F
FAN
HEAT
turns the unit on and off. When the unit is plugged into an appropriate electrical
RECOMMENDED
POWER
TIMER
TIMER
SLEEP
WATER
SLEEP
FULL
(3) (2) (1)
POWER
TIMER
TIMER
SLEEP
WATER
SLEEP
FULL
EN 4
50 cm / 20"
(1) Power Control
(2) Indicator Lights
(3) Timer Control / Sleep Control
(4) Timer / Temperature Set Controls
(5) Mode Control
(6) Fan Speed Control