Pioneer HTP-SB300 Mode D'emploi page 25

Listening to your system
Setting What it does
a Specifies how dual mono encoded Dolby Digital
DUAL MONO
soundtracks should be played.
DRC Adjusts the level of dynamic range for movie
(Dynamic Range soundtracks optimized for Dolby Digital, DTS, Dolby
Control) Digital Plus and Dolby TrueHD (you may need to use
this feature when listening to surround sound at low
volumes).
LFE ATT Some Dolby Digital and DTS audio sources include
(LFE Attenuate) ultra-low bass tones. Set the LFE attenuator as
necessary to prevent the ultra-low bass tones from
distorting the sound from the speakers.
The LFE is not limited when set to 0 dB, which is the
recommended value. When set to –10 dB, the LFE is
limited by the respective degree. When OFF is
selected, no sound is output from the LFE channel.
HDMI Specifies the routing of the HDMI audio signal out of
(HDMI Audio) this system (amp) or through to a TV or flat panel TV.
When THRU is selected, no sound is output from this
system.
A.DLY
This feature automatically corrects the audio-to-video
(Auto Delay) delay between components connected with an HDMI
cable. The audio delay time is set depending on the
operational status of the display connected with an
HDMI cable. The video delay time is automatically
adjusted according to the audio delay time.
d Spreads the center channel between the front right
C.WIDTH
and left speakers, making it sound wider (higher
(Center Width)
settings) or narrower (lower settings).
d Adjusts the surround sound balance from front to
DIMEN.
back, making the sound more distant (minus
(Dimension)
settings), or more forward (positive settings).
Option(s)
CH1 –
Channel 1 is heard only
CH2 –
Channel 2 is heard only
CH1 CH2 –
Both channels heard
from front speakers
b
AUTO
MAX
MID
OFF
LFEATT 0 (0 dB)
LFEATT 10 (–10 dB)/
LFEATT ** (OFF)
AMP
THRU
OFF
ON
c
0 to 7
Default: 3
–3 to +3
Default: 0
04
25
En