Connecting The Volume Remote Control; Operation - Conrad Electronic FS8 Notice D'emploi

10. Connecting the volume remote control

• Install the connecting cable from the installation place of the volume remote control to the subwoofer.
• Connect the volume remote control to the REMOTE LEVEL connection (11) on the subwoofer.

11. Operation

After connecting and checking the connections, you can start using the subwoofer.
• When you have checked the cable connections, reconnect the negative terminal of the battery.
• Put the POWER MODE switch (1) in the position of your preferred connection type:
AUTO POWER is for connection via the loudspeakers. The REM connection of the terminal (7) is not connected.

In this position, the subwoofer is switched on as soon as an audio signal is recognised.
REMOTE WIRE is chosen when the REM connection of the terminal (7) is connected to the control output of the
car radio.

In this position, the subwoofer is switched on as soon as a 12V control signal is present
at the terminal (7).
• Turn the LEVEL control (2) anti-clockwise to the minimum.
• Turn the control on the volume remote control anti-clockwise to the minimum.
• Turn the BASS EQ control (3) anti-clockwise to the minimum.
• Turn the PHASE control (4) anti-clockwise to the minimum.
• Put the FREQ control (5) in middle position.
• Switch on your car radio. The POWER indicator (6) lights up. If the POWER indicator (6) does not light up, an
error has occurred and the subwoofer has to be switched off immediately. If this is the case, check all the
connections and loudspeakers. If you cannot find the error, please consult a specialist.
• If the POWER indicator lights up, set the volume of the car radio to medium level.
• Put the control on the volume remote control in middle position.
28