Safety Instructions - Conrad Electronic FS8 Notice D'emploi

4. Safety instructions

The guarantee/warranty will be void if damage is incurred resulting from non-compliance with
the operating instructions. We do not assume liability for any resulting damage.
Nor do we assume liability for damage to property or personal injury caused by improper use
or failure to observe the safety instructions. In such cases the warranty/guarantee is voided.
Dear Customer, the following safety instructions are intended not only for the protection of the device but
also for the protection of your health. Please read through the following points attentively:
• The unauthorized conversion and/or modification of the product is inadmissible for safety and
approval reasons.
• The device may only be powered by the 12 V DC vehicle power supply (with the negative terminal
of the battery connected to the body of the vehicle). Never connect the product to any other power
supply.
• To make sure the device is set up properly, observe these operating instructions.
• Never pour liquids on electrical devices and do not place any containers filled with liquids (e.g. vases)
on them. This poses a serious risk of fire or electric shock. If such a case does occur, disconnect
the power supply immediately and consult a specialist.
• Do not expose the device to high temperatures, dripping or splashing water, strong vibrations or
heavy mechanical stress.
• Consult an expert when in doubt as to the operation, the safety or the connection of the device.
• This product is not a toy and should be kept out of the reach of children! Children cannot judge the
dangers involved when handling electrical devices.
• Do not leave packaging material lying around unattended. It may become a dangerous toy for
children.
• Do not operate the device when it is unattended.
• Only use the device in a moderate climate, and avoid a tropical environment.
• Also observe the safety and operating instructions of any other devices connected.
• Observe the additional safety instructions in each individual section of these instructions.
• If you are not sure about the correct connection or if questions arise which are not covered in these
operating instructions, please do not hesitate to contact our technical support or another specialist.
21