Triton TSPST 450 Instructions D'utilisation Et Consignes De Sécurité page 10

4. Carefully remove brush assembly (Image F)
5. Disconnect wire attached to brush assembly and remove brush
6. Fit replacement brush and reconnect wire
7. Replace motor brush assembly ensuring small leg is correctly in place (arrowed in Image
F)
8. Refit brush cover and refit screws
9. Repeat these Steps 3–8 with the other brush assembly. It is important to always replace
brushes in pairs
10. Re-install and tighten base plate
Alternatively, have the machine serviced at an authorised service centre
Contact
For technical or repair service advice, please contact the helpline on +1 (855) 227 3478
Web: tritontools.com/en-US/Support
Address:
Toolstream Inc,
380 Crompton
St, Charlotte,
NC 28273, USA
Troubleshooting
Problem
No function when ON/OFF Switch is operated
Sanding Sleeve (25) does not rotate with Sleeve Drum (31)
Sanding Belt does not remain at same height in use
Large amounts of dust are being produced
Sanding drum not operating at full speed or motor sounds
different to normal
EN
10
Storage
• Store this tool carefully in a secure, dry place out of the reach of children. If the tool
is permanently set up in a workshop or garage, ensure access is restricted to prevent
children operating the tool.
Disposal
Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE),
with household waste
• Contact your local waste disposal authority for information on the correct way to dispose
of power tools
Possible cause
No power
Defective ON/OFF Switch
Spindle Nut (27) not tight enough
Tracking adjustment incorrect
Dust extractor passage is blocked
Incorrect Throat Plate used
Motor over-heating
Motor faulty
Brushes need replacing
Motor belt worn or stretched
Solution
Check power supply
Have the ON/OFF Switch replaced at an authorised Triton
service centre
Tighten Spindle Nut in small increments until the Sleeve
Drum secures the Sanding Sleeve
See 'Tracking adjustment'
Turn off the machine at the mains. Remove the spindle
sander components or belt sander unit and remove the
blockage from the dust extractor passage
Change to the correct-sized Throat Plate
Switch OFF and allow to cool for a ½ hour
Contact an authorised Triton service centre
See 'Brush replacement'
Contact an authorised Triton service centre