Shell SH916WC Guide De L'utilisateur page 10

Jumper cable signal
Red Green
LED LED
Flashing Flashing
Flashing Off
Off Flashing
*Warning
Use "BOOST" with extreme care. Clamps must be tightly connected to the
correct polarities of the vehicle's battery before pressing boost button. Spark
proof and other safety protections will be disabled after pressing boost
button. This mode generates very high current. Sparks will generate when
clamps touch or are connected to each other. It may cause damage to the
product and the vehicle's electrical system if not used properly. Seek
professional assistance if you are not sure about using this mode.
Charging Portable Devices
1. Connect your portable device with one end of the correct USB cable,
and insert the other end to one of the output ports (USB-A 1, USB-A 2 or
Type-C port) of the jump starter. (Note: connect the USB PD compatible
device to Type-C port for fast charging. )
8
Cause
Sound
Jump started 4
Off consecutive times
within 10 minutes
Over-current
Beeping
protection/
with
short- circuit
intervals
protection
1. Clamps are not
connected to the
vehicle battery
Off
2. Vehicle's battery
voltage is too low or
cannot be detected
Solutions
Do not jump start more than 4 times.
Disconnect the clamps from the
vehicle's battery. Unplug the
jumper cable from the jump starter.
Consult a mechanic.
Disconnect the jump starter and
jumper cable from the vehicle.
Wait 30 seconds. Follow jump
starting vehicle instructions to
jump start the vehicle.
Make sure the clamps are securely
connected to the correct polarities
of the vehicle's battery.
Make sure the clamps are securely
connected to the correct polarities
of the vehicle's battery.
Press "BOOST" on the jumper cable.
Solid green LED light will turn on.
Jump start the vehicle.
*seeing warning below