Waste Electrical And Electronic Equipment - Gallagher M1800i Notice D'installation

Gallagher 3E2489 M1800i M2800i Energizer User Manual
TROUBLESHOOTING
Problem
Energizer has started to run
slowly
Displaying Error 11
Displaying Error 12
Displaying Error 14–19
Displaying Error 21
Energizer output voltage is
low
Earth voltage is too high
No output and display shows
( - - )
Save these instruc ons.
WASTE ELECTRICAL AND ELECTRONIC
EQUIPMENT
This symbol on the product indicates that this product, packaging and with special
care of the ba ery must not be disposed of with other waste. Instead, it is your
responsibility to dispose of your waste equipment by handing it over to a designated
collec on point for the recycling of waste electrical and electronic equipment. The
separate collec on and recycling of your waste equipment at the me of disposal
will help conserve natural resources and ensure that it is recycled in a manner that
protects human health and the environment. For more informa on about where
you can drop off your waste equipment for recycling, please contact your local city
recycling offi ce or the dealer from whom you purchased the product.
Causes
The internal temperature of
the energizer is too high
Mains voltage is too high
Mains voltage is too low
Internal energizer fault
Dead zone
There is a fault on the fence
Earth system is inadequate
Energizer is in standby mode Exit standby mode by
Solution
Mount the energizer in a cool
area, out of direct sun and
with adequate ven la on
Have your power supply
checked by a professional
electrician
Have your power supply
checked by a professional
electrician
Turn energizer off for 30
seconds then turn back on. If
the error remains return the
energizer to your Gallagher
dealer for servicing.
Check that the zone device
is connected and working
correctly.
Remove any excess grass
growth or short circuits on
the fence.
Check connec ons to the
earth system. Add extra
earth stakes.
pressing the standby bu on
on the controller
19