Bestron AST9000 Mode D'emploi page 38

PROBLEM
The iron is leaking brown fluids.
The iron is leaking white fluids.
The device discharges little to no
steam.
Ironing leaves stains on the
clothes.
Steam or water leaks from the
bottom of the steam station.
POSSIBLE CAUSE
The water contains additives
(like descaling agents, perfumed
water or starch).
The water tank contains
limescale.
The water tank is empty.
__________________________
The water does not reach
the correct temperature.
__________________________
The water tank has been placed
incorrectly.
The ironing temperature is too
high for the type of fabric you are
ironing.
__________________________
You are directly ironing over the
applied starch.
__________________________
The garments have been
insufficiently rinsed and contain
soap residue.
__________________________
The garments are new and have
not yet been washed.
The device is defective.
38
POSSIBLE SOLUTION
Do not add any additives
whatsoever to the water. If you
did do this, then please contact
our service department, the
address can be found in the back
of the manual.
Rinse the tank as described in
'Cleaning and Maintenance –
Rinsing the tank'.
Fill the water tank.
__________________________
Wait until the pilot light turns
off, this means the correct
temperature has been reached.
__________________________
Make sure the water tank
is placed correctly. Press it
downwards with the help of the
'wings' on the side, so the tank
becomes lodged in its notch.
Make sure the device is set at
the temperature described in
the ironing instruction of your
garment.
__________________________
When using starch, make sure
you apply it to the back of the
area that is to be ironed.
__________________________
Thoroughly rinse your garments
to ensure they do not contain
any soap residue.
__________________________
Make sure your new garments
have been washed and rinsed
before ironing them.
Turn the device in for repairs.
Please contact our service
department, the address can be
found in the back of the manual.
EN