General Safety Rules - Genesis GFDP160 Manuel D'utilisation

16-Speed Floor Drill Press
Operator's Manual
Specifications:
• Model:
• Rated Voltage:
• Rated Input Power:
• No Load Speed:
• Max Drilling Capacity:
• Spindle Travel:
• Table Movement:
• Table Size:
• Base Size:
• Swing:
• Max. Distance from Spindle end to Surface of table:
• Max Distance from Spindle end to surface of base:
• Max Distance from Spindle Axis to Surface of Column:
Includes: Chuck key, Drift key and Allen wrenches
WArning:
this operator's manual before operating this tool. Save this Manual for future
reference.
Toll-Free Help Line: 1-888-552-8665
WeAR yOuR
SAFeTy GLASSeS
FOReSIGHT IS BeTTeR
THAN NO SIGHT
Look for this symbol to point out important safety
precautions. it means attention!!! Your safety is
involved.

gEnErAL SAFETY rULES

WArning:
Some dust created by power sanding, sawing, grinding, drilling, and other
construction activities contains chemicals known to cause cancer, birth defects
or other reproductive harm. Some examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and other masonry products, and
• Arsenic and chromium from chemically treated lumber.
Your risk from these exposures varies, depending on how often you do this
type of work. To reduce your exposure to these chemicals: work in a well
ventilated area, and work with approved safety equipment, such as those
16-Speed Floor Drill Press
Operator's Manual
GFDP160
120V~ 60HZ
6.6 Amp
16 Speeds 210-3840 RPM
5/8" (16 mm)
3-1/8" (80mm)
45° bevel, 360° swivel
10-5/8" x 10-5/8" (270 mm x 270 mm)
10 x 5/8" x 17-7/8 " (273mm x 456 mm)
13" (331 mm)
To reduce the risk of injury, user must read and understand
WArning:
objects being thrown into your eyes, which can result in severe eye damage.
Before beginning tool operation, always wear safety goggles or safety glasses
with side shields and a full face shield when needed. We recommend Wide
Vision Safety Mask for use over eyeglasses or standard safety glasses with
side shields. Always wear eye protection which is marked to comply with ANSI
Z87.1.
30-5/8" (780 mm)
47-5/8" (1210 mm)
6-5/8 " (169 mm)
The Operation of any power tool can result in foreign
GFDP160
6.6 AMP