Hema 45.10.0002 Mode D'emploi page 6

Lower thread
• When inserting or removing the lower bobbin, the needle must be fully raised.
• Turn the hand wheel (no.11). Pull out the plastic transparent cover (no. 9).
• Insert the bobbin in the bobbin case, so that the thread rund in a clockwise direction.
• Replace the transparent cover (no. 9)
• Raise the presser foot, hold the upper thread with the left hand, right hand turn the
handwheel anticlockwise until the needle is raised.
• When the needle reach the bottom, the hook tray will hook the upper thread, ro-
tate the hook tray to pull the lower thread out.
• Pull the lower and upper thread under presser foot (no. 8), pull out 10 cm to the back.
8
Winding of the bobbins
Figure 1
• Place a yarn pin on the spool pin (no.1).
• Guide the thread through the winding thread guide (no. 2) to the empty bobbin.
• Place the bobbin winding pin (no.18) on the machine.
• Wind the thread several times clockwise to the empty bobbin and place it on the
bobbin winding pin (no.18).
6
11