Basic Operation; Receiving And Transmitting - Icom IC-SAT100 Notice De Base

4

BASIC OPERATION

■ Receiving and transmitting

D Turning ON the transceiver
z Rotate [VOL] to turn ON the transceiver.
• The transceiver searches a satellite.
• When the transceiver connected and
registered to the satellite, the status
"IDLE," transceiver name, and Talkgroup
name is displayed.
L Push [Last Call] to playback the
received call.*
* See page 9 of the IC-SAT100
OPERATING MANUAL for Last Call
Play function details.
L Push [UP] or [DOWN] to display the
Talkgroup List.
L Rotate Talkgroup selector to select a
talkgroup.
D Receiving
When receiving, "LISTENING," and the
source transceiver's name is displayed,
and audio should be heard.
L Rotate [VOL] to adjust the audio output level.
LISTENING
TRANSCEIVER02
TALKGROUP01
Last Call
NOTE:
• The transceiver receives and transmits
using several satellites orbiting the same
orbit. Receiving and transmitting may fail
depending on the satellite position or any
obstacles between the transceiver and
satellites.
• Your body can also be an obstacle. Do not
hook the transceiver on your waist.
11
Ignore
D Transmitting
CAUTION: DO NOT transmit without an
antenna.
1. Hold down [PTT].
L "REQUESTING" is displayed while the
transceiver requests the transmission.
2. When "TALKING" is displayed, speak
at your normal voice level.
L You can continuously transmit up to the
period of time allowed by the system.
TALKING
TRANSCEIVER01
TALKGROUP01
Last Call Scan
NOTE:
• If the connection becomes poor while
transmitting, the transceiver sounds the
beep "PuPu" in 1.5 seconds interval.
• You cannot transmit while listening to
the received audio. Before transmitting,
confi rm the receiving is fi nished by the
beep "Pi" and the display "OPEN."
D Scan and Ignore
[Scan]
Push to scan a call.
[Ignore]
Push to ignore the received call.
L The Ignore function will be canceled if
there are no more calls for 90 seconds or
longer.