BALDER BSH1 Mode D'emploi page 9

AUTODARKENING WELDING FILTER AND PROTECTION SCREENS
ASSEMBLY / F10, F11, V913, V913 DS ADC /
1.
2.b
4.a
1. Release the metal locking spring (1.).
2. Place the inner protective screen on the inner
side of the electro-optical welding filter as
shown in figure (2.a). Insert the electro-optical
welding filter with the inner protective screen
between the supporting frame and the metal
spring until the electro-optical welding filter is
secured in the supporting frame by the metal
spring (2.b).
3.
Lift the supporting frame with the welding filter
2.a
and put the outer protective screen in place (3.).
4. Lower the supporting frame with welding filter
(4.a) and lock the metal locking spring in posi-
tion (4.b).
3.
4.b
9