Publicité
Les langues disponibles
Les langues disponibles
- Date of installation
- Replace before date (5 years from the date of installation)
- Model of gas leak detector installed
- Room where the gas leak detector has been installed
- Installer's stamp and signature
Programming:
The "Gas Sentinel" gas leak detectors are equipped with electronics based on the latest generation of
microprocessor and they allow programming certain functions.
When the "Prog" button is pressed for 5-6 seconds, the leak detector enters programming mode
(green LED flashing), the red LED shows the procedure activated while the yellow LED indicates the
status of the parameter which can be modified within the procedure selected.
A brief pressing of the "Prog" button changes the leak detector status from slave to master. Yellow
LED unlit = slave (default ) and Yellow LED lit up = Master. To quit programming, merely wait for
20-30 seconds: after this time has elapsed, the leak detector automatically returns to the normal mode
of operation
24
Publicité
