Epson L3100 Série Guide Rapide page 3

Button Combinations
Reading the Indication Lights
: On : Flashing
Error Status
Initial ink charging may not be complete. See the Start Here to complete initial ink charging.
No paper is loaded or more than one sheet has been fed at a time. Load paper and press the
A paper jam has occurred. Remove the paper and press the
& "Clearing Paper Jam" on page 45
If the indicator light continues flashing, see the jammed paper section from "Solving Problems"
in the User's Guide.
O When the power light is on or flashing, the printer was not turned off correctly. After
clearing the error by pressing the
recommend performing a nozzle check because the nozzles may have dried or clogged.
To turn off the printer, make sure you press the
O When the power light is off, the printer has started in recovery mode because a firmware
update failed. For more details, see the error indicator table from "Solving Problems" in the
User's Guide.
O Flashing simultaneously: An ink pad is nearing or at the end of its service life.
O Flashing alternately: A borderless printing ink pad is nearing or at the end of its service life.
Borderless printing is not available, but printing with a border is available.
To replace the ink pad or borderless printing ink pad, contact Epson or an authorized Epson
service provider.
A printer error has occurred. Open the front cover and remove any paper inside the printer. Turn
the power off and on again. If the error continues to occur after turning the power off and on
again, contact Epson support.
Press the and buttons simultaneously to run software on a USB-connected
computer and scan as a PDF file.
Press the and the or
Turn the printer on while holding down the
or button.
buttons simultaneously to copy in draft mode.
button to print the nozzle check pattern.
or
or button, cancel any pending print jobs. We
button.
3
button.
34
EN
FR
ES
PT
TR
SW
AR
FA