Repair Service; Technical Data - Deltafox DG-EHT 6860 3D Notice D'utilisation Originale

GB
services is that the maintenance intervals
indicated in the operating instructions
have been observed and the instructions
for cleaning, care and maintenance have
been followed. Damages due to material
or manufacturer faults will be repaired free
of charge by replacement delivery or re-
pair. However, this is conditional upon the
unit being returned complete and assem-
bled to our Service Centre, together with
proof of purchase and guarantee slip.

Repair Service

Repairs that are not covered by the guar-
antee can be carried out by our Service
Centre for a fee. Our Service Centre will
be happy to provide you with a cost esti-
mate. We can deal only with equipment
that has been packaged correctly and
which has been sent to us with the correct
postage paid.
If you have a justified guarantee claim,
please contact our Service Centre by
telephone, from which you will then be ad-
vised on how the claim will be processed.
Caution: The sender shall bear the cost of
any material damages during transport.
In case of complaint or for servicing,
please send your equipment cleaned and
with an indication of the defect, to our
service address.
Equipment sent in with freight collect –
by bulk freight, express or with other
special freight – are not accepted.
We can dispose of your equipment free of
charge.

Technical Data

Electric hedge trimmer .. DG-EHT 6860 3D
Input voltage rating ......230-240 V~, 50 Hz
Input power ..................................... 680 W
Safety class .........................................
62
Protection category............................ IPX0
Knife movements per minutes ..1500 min
Weight ..............................approx. 3.89 kg
Cutting length ...............................610 mm
Sound power level (L
measured ...... 98.15 dB (A); K
guaranteed ............................101 dB (A)
Sound pressure level
(L ) ...............91.52 dB (A); K
pA
Vibration (a )
h
at the bow handle ..................3.266 m/s
at the handle .........................2.831 m/s
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning:
The vibration emission value may
differ during actual use of the
power tool from the stated value
depending on the manner in which
the power tool is used. Safety pre-
cautions aimed at protecting the
user should be based on estimated
exposure under actual usage con-
ditions (all parts of the operating
cycle are to be considered, includ-
ing, for example, times during
which the power tool is turned off
and times when the tool is turned
on but is running idle).
Noise and vibration values have been de-
termined according to the standards and
regulations mentioned in the declaration
of conformity.
II
)
WA
= 3.0 dB
WA
= 3.0 dB
pA
K= 1.5 m/s
-1
2
2
2