Cameo PIXBAR DTW PRO Manuel D'utilisation page 9

Settings
Display Backlight = Display
lighting
DMX Fail = operating status
with DMX signal
fault
Dimmer Curve = dimmer curve
Dimmer Response = dimmer response
Redshift = accurately mimics
(DTW) the colour drift
Dim to Warm of dimming a
halogen spotlight.
When dimming
the spotlight, the
colour temper-
ature changes
automatically to
increasingly warm
white and amber
(and vice versa).
White Balance = colour calibration
Autolock = automatic locking
of the controls
Factory Reset = reset to factory
setting
On
Off Deactivation after approximately 1 minute of inactivity
Hold Last command is retained
Blackout Activates blackout
Linear Light intensity increases linearly with DMX value
Exponential Light intensity can be finely adjusted at lower DMX values and broadly
adjusted at higher DMX values
Logarithmic Light intensity can be broadly adjusted at lower DMX values and finely
adjusted at higher DMX values
S-Curve Light intensity can be finely adjusted at lower and higher DMX values
and broadly adjusted at medium DMX values
LED Lamp responds directly to changes in DMX value
Halogen Lamp behaves like a halogen spotlight with delayed brightness chang-
es and without changes in colour
Off Colour drift is disabled
On Colour drift is enabled
For optimum halogen dimming characteristics, set the dimmer
response to Halogen and colour drift to On.
The Redshift function only affects the dimmer circuits, not the colour
channels, such as A, WW, CW.
Amber, Cold Individual colour calibration. Cross-mode brightness setting of the 3
White, Warm LED groups A, CW and WW with values from 000 to 255
White
Off Automatic locking of the controls is disabled
On Automatic locking of the controls after approximately 1 minute of
inactivity. Display shows: "LOCKED"
To unlock: Press and hold UP and DOWN simultaneously
for approx. 3 seconds
Factory ENTER = Reset/MODE = Cancel
Reset?
9