Peak 3D MULTIHORSE 5200 Guide De L'utilisateur page 4

Table Assembly Instructions
Safety Information
• IMPORTANT: READ THE ENTIRE SAFETY INFORMATION SECTION AT THE BEGINNING OF
THIS MANUAL BEFORE SET UP OR USE. READ ALL INSTRUCTIONS CAREFULLY. FAILURE
TO FOLLOW ALL INSTRUCTIONS CAN RESULT IN DEATH OR SERIOUS INJURY.
• Do not build a Table higher than 3' (0.91 m) and larger than 8' (2.43 m) long by 4' (1.21 m) wide.
Required materials
- Two 2x4 Long Stringers - max. length 8' (2.43 m)
- Two 2x4 Short Stringers - max. length 41" (1.04 m)
- Two 2x4 Spacers - max. length 4' (1.21 m)
- One 4' x 8' x ¾" (1.21 m x 2.43 m x 19 mm) sheet of plywood
- Four 2x4 Legs - max. length 3' (0.91 m)
- Sixteen #10x1¼" (32 mm) wood screws (provided)
- Twenty-two #10x2" (51 mm) wood screws (not provided)
Note: All lumber must be No. 1 structural grade that is free of cracks, splitting, loose or
large knots, decay, twist, and/or any other defect.
Installation
1. Begin by placing the Long and Short
Stringers on a flat level surface.
2. Attach the plywood sheet to the Stringers
using twenty-two #10x2" (51 mm) wood screws
spaced not more than 16" (406 mm) apart.
38.10 393.70
the Short Stringers should
be 10¼" (260 mm) from the
ends of the Long Stringers.
3. Install 2x4 Spacers into brackets and fasten at
each end with #10x1¼" (32 mm) wood screws.
4. Flip the plywood sheet over and fasten the brackets
to the Long Stringers using eight #10x1¼" (32 mm)
wood screws.
Ensure Table top does not
extend outward
more than 6" (152
mm) past brackets.
5. Install legs by releasing leg clamps,
inserting legs through leg clamps and sliding
to desired height.
Install Boots - refer to Sawhorse
Assembly Instructions, Step 3, for
Boot installation.
6. Carefully turn structure over
with the help of another person.
IMPORTANT: Legs
must never exceed 3'
(0.91 m) long.
Ensure each leg clamp
is fully engaged.
IMPORTANT:
Ensure top end of
each leg extends
beyond top of
each bracket.