Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CS 59 - USER'S TECHNICAL MANUAL
CONTENTS
TECHNICAL SPECIFICATIONS
OPTIONS
GUARANTEE
REASSEMBLY
LOADING THE WEDGE CARTRIDGE ON MACHINE
You have just bought a CS 59 frame joining machine, so we congratulate on your sensible
choice and thank you for your trust in Cassese products.
The CS 59 benefits from the experience of the joining machines that brought Cassese a
certain reputation. It makes it possible to join wooden mouldings of all profiles ( patent n°
7522814).
The CS 59 is designed to allow the operator to move all around the machine.
Page
The joining operation is carried out by using metal wedges especially designed to perform
2
a tight join. These wedges come in throw-away plastic cartridges, without glue, individu-
ally lubricated and rust-protected for the toughest challenges.
3, 4, 5
6
6,7
8
8
9
10
Minimum moulding width : 3mm (1/8") Minimum moulding height : 7 mm (¼")
Maximum moulding width :
11
Furthest stapling position from back of moulding (at 45°) : 74 mm (3")
Wedge sizes in cartridges of 275 pieces : 3, 4, 5, 7, 10, 12 and 15 mm.
Two wedge types : for soft and for hardwoods.
Machine gross weight : 22 kg (47 lbs)
Dimensions : 493mm(19''2/5) x 600mm (23''2/3)(w/out extension table)
One year guarantee for parts and labour against manufacturing defects. Wear parts and
those damaged as a result of non appliance with the instructions of the present manual are
excluded from the guarantee.
INTRODUCTION
IMPORTANT : You should not use other wedge cartridges than those manufactured by
Cassese and marketed by official Cassese distributors (registered mark CS).
BEWARE OF COPIES.
ACCESSORIES SUPPLIED WITH THE MACHINE
6, 5, 4, 3 mm
+ 1 Table + 1 Foot pedal + 1 Support + 1
TECHNICAL SPECIFICATIONS OF CS 59
f
Maximum moulding height : 80 mm ( 3"1/4 )
1095 mm high (43'' 1/10)
GUARANTEE
x4
Short green rubber for hardwood
2
Publicité
Table des Matières
