Battery Removal/Installation - Hitachi WH 8DH Mode D'emploi

3. Wood working drill bit: Code No. 959183
4. Drill chuck adapter set: Code No. 996195
Use the drills available on the local market.
5. Holster: Code No. 307824
Use the holster to hold the unit during its operation.
Carefully read the warnings attached to the holster
for safe use.
6. Hook: Code No. 308090
Use the hook to hold the unit during its operation.
Carefully read the instructions that come with the
hook to learn how to use it.
Optional accessories are subject to change without
notice.
Table 1
Blinks
Before
(RED)
charging
Lights
While
(RED)
charging
Blinks
Charging
complete (RED)
Charging Flickers
impossible (RED)
Lights
Charging
(GREEN)
impossible
APPLICATION
Driving and removing of small screws, small bolts,
etc.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the hadle tightly and push the battery latch
to remove the battery. (Figs. 1 and 2)
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
Before using the impact driver, charge the battery as
follows.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals).
2. Insert the battery into the charger.
Position the battery so that the nameplate faces
toward the caution plate of the charger and push
in the battery until it contacts the bottom plate. (See
Figs. 1 and 3.)
CAUTION
If the battery is inserted in the reverse direction,
not only recharging will become impossible, but it
may also cause the fuse to blow, or problems in
the charger such as deformed recharging terminal.
3. Charging
When inserting a battery in the charger, charging
will commence and the pilot lamp will light con-
tinuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals.) (See
Table 1)
Pilot lamp indication
The indications of the pilot lamp will be as shown
in Table 1, according to the condition of the charger
or the rechargeable battery.
Indications of the lamps
Lights for 0.5 seconds. Does not light for
0.5 seconds. (off for 0.5 seconds)
Lights continuously
Lights for 0.5 seconds. Does not light for
0.5 seconds. (off for 0.5 seconds)
Lights for 0.1 seconds. Does not light for
0.1 seconds. (off for 0.1 seconds)
Lights continuously
English
Malfunction in the battery
or the charger
The battery temperature
is high, making recharg-
ing impossible.
5