Technical Data - PROLUMIA LED PRO-AQUA II + Manuel D'utilisation

ATTENTION
Please read the following instructions carefully to ensure that mounting operation will be carried out correctly. These instructions
should be properly preserved for future reference.
CAUTION
1. The product must be installed by qualified technicians. The power supply must be cut before installation.
2. The installation wiring must be 3x 1,0 - 2,5mm² at least and wired in accordance with the latest IEE electrical regulations or the national
requirements.
3. Do not touch the electronic circuit and its components.
4. Do not touch the LEDs while installing or maintaining.
5. The LED light source of the fixture cannot be replaced. The complete product must be replaced if the light source is broken.

TECHNICAL DATA

Supply voltage: AC 220-240V 50/60Hz
Light source: LED SMD2835
Operating temperature: -25°C - +50°C
Electrical safety class: Class I
LED Pro-Aqua II - 664mm
LED Pro-Aqua II - 1274mm
LED Pro-Aqua II - 1574mm
6
90
90
350
664
90
90
900
1274
90
90
1200
1574
www.prolumia.eu
140
90
350
664
LED Pro-Aqua II High power - 664mm
140
90
900
1274
LED Pro-Aqua II High power - 1274mm
140
90
1200
1574
LED Pro-Aqua II High power - 1574mm