Installation And Commissioning - Fiap LIGHT ACTIVE SET Notice D'emploi

GB LIGHTING TECHNOLOGY
All work with this device may only be carried out in accordance with these instructions.
The combination of water and electricity can lead to serious danger to life and limb if it is
not connected properly or handled improperly.
Only operate the device when there are no people in the water!
Before reaching into the water, always unplug all devices in the water. Compare the
electrical data of the power supply with the type plate on the packaging or on the device.
Make sure that the device is protected by a residual current device with a rated residu-
al current of maximum 30 mA. Only operate the device from a properly installed socket.
Keep the power plug and all connection points dry! Lay the connection cable in a protec-
ted manner so that damage is impossible. Only use cables, installations, adapters, extensi-
on or connection lines with protective contact that are approved for outdoor use. Do not
carry or pull the device by the connecting cable! The device must not be operated if the
cable or housing is defective! If the power cord of the device is damaged, the device must
be disposed of; it is no longer possible to replace the power cord. If the cable is damaged,
the device must be disposed of. Electrical installations on garden ponds must comply with
international and national installation regulations. Never open the housing of the device
or its associated parts unless this is expressly stated in the instructions for use. Never
make technical changes to the device, this leads to the immediate expiry of all
warranty and guarantee claims. Use only original spare parts and accessories. Have
Never operate the
repairs carried out only by authorized customer service centers.
device without water flowing through it!
Never pump liquids other than water! For
your own safety, contact a qualified electrician if you have any questions or problems!
Caution, LED light: do not look into the LED light beam! Do not look at it directly
or with optical instruments!

INSTALLATION AND COMMISSIONING

The device is delivered fully assembled as a complete set with power supply unit, twilight
switch, three LED headlights including lamps and 5 different colored discs (green, red,
blue, yellow, white). When installing above water, a safety distance of at least 50 cm from
flammable material must be maintained. Make sure you have a secure footing. Covering
the device is not permitted. Fire hazard!
Position the device so that it does not pose a hazard to anyone. Thanks to the weighted
feet, it can be set up very easily and without tools. You can easily adjust the inclination of
each individual light by hand in five stages, the light engages automatically. Mount the twi-
light switch with the included in delivery Ground spike. Connect the plug of the connec-
tion cable to the socket on the transformer. Insert the power plug of the transformer
into the power socket. Check the function of the lights.
It is not possible to operate the LED light on a dimmer. The light intensity of an LED
decreases with increasing operating time. To change the colored discs or the lamp, un-
screw the lock counterclockwise.
When assembling, ensure that the undamaged seal is seated correctly.
7