Monster tulpar T5 V21.6 Manuel De L'utilisateur page 22

• Change Administrator Password
When this item is selected, a message box shall appear on the screen as below:
Enter New Passwor
- Type a maximum of 20-digit password and press [Enter].
- The password typed now will replace any previously set password from CMOS
memory. You may also press [ESC] to abandon new password setting. It is
extremely important to keep record for any BIOS password which is set as it can
not be reset even with the removal of a CMOS battery for the security of your PC.
- Select Change User Password to give or to abandon password setting same as
Change Administrator Password item above.
- Note that Administrator Password feld allows users to enter and change the
settings of the BIOS SETUP UTILITY, while User Password feld only allows users
to enter the BIOS SETUP UTILITY without having the authorization to make any
change.
- The Password Check item is used to specify the type of BIOS password
protection that is implemented.
- To clear a set Administrator Password/ User Password, just press [Enter]
under Change Administrator Password/ Change User Password feld when you
are prompted to enter the password. A message box will pop up confrming
password will be disabled.Once the password is disabled, the system will boot
and user can enter setup without entering password.
• Key Management:
Enables expert user to modify Secure Boot Policy variables without full
authentication.
EN
21