First Use; Setting The Water Softener; Water Hardness - ETNA VW147ZIL Mode D'emploi

FIRST USE

Before using the dishwasher for the first time:
• Set the water hardness.
• Add 1 litre of water to the salt reservoir and then add 1.5 kg of dishwasher salt.
• Add rinse agent.
• Add detergent.

Setting the water softener

1. Open the door.
2. Press the "on/off" button to switch on the appliance.
3. Press the Program button for more than 5 seconds to start the water softener set model
within 60 seconds after the appliance was switched on (the water softener and Rinse agent
warning lights will be on periodically when it get in the set model ).
4. Press the Program button to select the proper set according to your local environment,
the sets will change in the following sequence: H1->H2->H3->H4->H5->H6 / see water
softener table.
5. Press the "on/off" button to end the setup mode.
Water softener table
ºClarke
0 - 6
7 - 14
15 - 21
22 - 28
29 - 42
43 - 69
The manufactory setting: H3 (EN 50242)
Contact your local water authority for information on the water hardness of your water supply.
EN 6

Water hardness

ºdH mmol/l
0 - 5 0 - 0,94
6 - 11 1,0 - 2,0
12 - 17 2,1 - 3,0
18 - 22 3,1 - 4,0
23 - 34 4,1 - 6,0
35 - 55 6,1 - 9,8
setting in Salt
display consumption
(grams/cycle)
H1 0
H2 9
H3 12
H4 20
H5 30
H6 60