Table des Matières
Publicité
PREPARATION BY THE PURCHASER
•
Preparation of the installation site.
The purchaser must prepare the surface on which the machine will stand suitable to support the
machine weight (see the installation chapter).
•
Electrical requirements.
The mains power installation must comply with the safely regulations and standards in force in the
country of installation and must include an efficient earth system. An omnipolar cut-off device must
be installed on the power line upstream of the machine.
The power wires must be sized according to the maximum current required by the
machine to ensure a total voltage loss under full load of less than 2%.
•
Plumbing requirements.
Prepare a suitable drain and a mains that supply water a maximum hardness of 3/5 French degrees
(60/85 ppm).
SYMBOLS
C
A
B
D
E
RESIDUAL RISKS
Although the manufacturer has provided mechanical and electrical safety systems, dangerous areas
persist during the use of the machine:
14
A
General hazard
B
Electrical shock hazard
C
Burns hazard
D
Hazard of damage to the machine
E
Operation reserved for the qualified technician, in compliance with current
standards
•
Coffee dispensing groups.
•
Steam wand.
•
Hot water wand.
•
Cup warmer.
Publicité
Table des Matières
