Replacing Carbon Brushes - SSP MRP101 Manuel D'instruction

Dust cover (For tool with the knob)
(optional accessory)
005113
Dust cover prevents sawdust from being drawn into the
tool in the inverted position.
Install the dust cover as illustrated when using the tool
with a router stand available in the market.
Remove it when using the tool in the normal position.
Spacer (For tool with the knob)
1
005114
The spacer prevents the router bit from dropping into the
chuck when replacing the bit in the inverted position.
Insert the spacer as illustrated when using the tool with a
router stand available in the market.
Dust extraction (Accessory)
1
004939
Use the vacuum head for dust extraction. To Install the
vacuum head, raise the lock lever on it. Place the
vacuum head on the tool base so that its top will be
caught in the hook on the tool base. Insert the supports
on the vacuum head into the hooks on the front of the tool
base.
Push down the lock lever onto the tool base.
1. Pan head screw
1
2. Dust cover
2
1. Collet nut
2. Collet cone
2
3. Spacer
3
1. Vacuum head
1
2
004940
Then connect a vacuum cleaner to the vacuum head.
004941
To remove the vacuum head, raise the lock lever. Pull the
vacuum head out of the tool base while holding the
supports between thumb and finger.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
8
1. Support
2. Lock lever
1. Limit mark
1