SSP MRP101 Manuel D'instruction page 6

Set the tool base on the workpiece to be cut without the
bit making any contact. Then turn the tool on and wait
until the bit attains full speed. Lower the tool body and
move the tool forward over the workpiece surface,
keeping the tool base flush and advancing smoothly until
the cutting is complete.
When doing edge cutting, the workpiece surface should
be on the left side of the bit in the feed direction.
4
1
2
3
1. Workpiece
2. Bit revolving direction
3. View from the top of the tool
4. Feed direction
001984
NOTE:
Moving the tool forward too fast may cause a poor
•
quality of cut, or damage to the bit or motor. Moving
the tool forward too slowly may burn and mar the
cut. The proper feed rate will depend on the bit size,
the kind of workpiece and depth of cut. Before
beginning the cut on the actual workpiece, it is
advisable to make a sample cut on a piece of scrap
lumber. This will show exactly how the cut will look
as well as enable you to check dimensions.
2
1
001985
NOTE:
When using the straight guide or the trimmer guide,
•
be sure to install it on the right side in the feed
direction. This will help to keep it flush with the side
of the workpiece.
2
4
1. Feed direction
3
2. Bit revolving
direction
3. Workpiece
4. Straight guide
4
Straight guide
1
004929
The straight guide is effectively used for straight cuts
when chamfering or grooving.
Install the straight guide on the guide holder with the wing
bolt (B). Insert the guide holder into the holes in the tool
base and tighten the wing bolt (A). To adjust the distance
between the bit and the straight guide, loosen the wing
bolt (B) and turn the fine adjusting screw (1.5 mm or
about 1/16" per turn). At the desired distance, tighten the
wing bolt (B) to secure the straight guide in place.
1
2
3
4
004930
Wider straight guide of desired dimensions may be made
by using the convenient holes in the guide to bolt on extra
pieces of wood.
1
2
55 mm
( 2-3/16" )
3
003684
When using a large diameter bit, attach pieces of wood to
the straight guide which have a thickness of more than
15 mm (5/8") to prevent the bit from striking the straight
guide.
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
6
1. Straight guide
1. Wing bolt (A)
2. Guide holder
3. Fine adjusting
screw
4. Wing bolt (B)
5. Straight guide
5
1. More than 15mm
(5/8")
2. Straight guide
3. Wood
55 mm
( 2-3/16" )