Assembly - Delta AP-300 Manuel D'utilisation

For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
INSTALLING THE CASTERS
1. Place the dust collector on its side.
2. Insert a caster through the four holes (A) Fig. 3 in the base of the dust collector.
3. Thread a 3/8-16 flange hex nut (B) Fig. 4 onto each of the four bolts and tighten securely.
INSTALLING THE EXHAUST FLANGE
1. Align the holes in the exhaust flange (A) Fig. 5 with the holes in the exhaust flange gasket (B).
2. Insert a 5/16-18x5/8" hex-head bolt through the exhaust flange, the exhaust flange gasket, and the base unit (Fig.
6).
3. Thread a 5/16-18 hex nut (B) onto the 5/16-18x5/8" hex head bolt (A) Fig. 6 and tighten securely.
4. Repeat this process for the three remaining bolts.
Fig. 3
Fig. 5

ASSEMBLY

ASSEMBLY TOOLS REQUIRED
1/2" & 9/16" Open or Box End Wrench
9/16"
1/2" & Socket and Drive - not provided
Flat or Phillips Screwdriver
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes approximately 1-2 hours.
A
A
B
- not provided
- not provided
Fig. 4
A
Fig. 6
8 8
B
B