Maico EAT 6 G/1 Notice De Montage Et Mode D'emploi page 8

Temperature control system
EAT 6 G/1
Please read the instructions carefully
before mounting and using for the
first time. Follow the instructions.
Pass these instructions onto the
owner for safekeeping.
Unit overview, Figure A
1 EAT 6 G/1 unit with plexiglass cover
2 Operating mode switch with Automatic -
Off - Continuous switch positions
3 Potentiometer, minimum fan speed
4 Potentiometer, "XP" speed range,
setting range 2 ... 10 K
5 Potentiometer, maximum fan speed
6 Snap-fit fastener
7 Terminal box cover
8 Setpoint temperature rotary knob,
setting range 5 ... 35 °C
9 Indicator lamp for fault = red: if a short
circuit has occurred or cable to
temperature sensor is interrupted.
10 Indicator lamp for limit value = yellow:
if fan is switched off during limit value
switch-off.
11 Indicator lamp for operation = green:
if unit is switched on.
12 Jumper for limit value switch-off
13 Temperature sensor
Table of contents
1. Specialist installer qualifications .......... 8
2. Intended use ....................................... 8
3. Safety instructions and warnings ......... 9
4. Product information ........................... 10
5. Environmental conditions and
operating limits .................................. 10
6. Technical data ................................... 10
7. Installation ......................................... 10
8
8. Electrical connection ......................... 11
9. Commissioning - temperature-
controlled operation ........................... 11
10. Commissioning - continuous operation 12
11. Switching off unit ............................... 12
12. Maintenance ..................................... 12
13. Cleaning ............................................ 12
14. Fault rectification ............................... 12
15. Dismantling ....................................... 12
16. Environmentally responsible disposal 12
17. Wiring diagram .................................. 20
1. Specialist installer
qualifications
Only a trained electrician is permitted to
work on the electrics. You are deemed a
trained electrician if you are familiar with the
relevant standards and guidelines, can
competently and safely create electrical
connections in line with the attached wiring
diagram and are able to recognise and avoid
risks and dangers associated with electricity
on the basis of your technical training and
experience.
2. Intended use
The EAT 6 G/1 unit regulates the room
temperature to an adjustable setpoint
temperature. The temperature is changed by
the supply of outside air with single-phase AC
fan(s). The room temperature is recorded by
a separate temperature sensor.
Operation is only permitted with:
● a fixed installation within buildings.
● a wall-mounted surface installation.
● if temperature sensor [13] is not covered.
Air must be able to reach the temperature
sensor unhindered.
Acknowledgements: © Maico Elektroapparate-
Fabrik GmbH. Translation of the original German
operating instructions. Misprints, errors and technical
changes are reserved.